Look at the back edge of the engine cowling on a Boeing 787 or a 737 MAX and you will see a row of triangular teeth. They are called chevrons, and they are there to cut noise.

Where they came from

NASA says the idea started with the military, which put rectangular tabs on nozzle exits to disguise the heat signature of jet exhaust. Researchers at NASA's Glenn Research Center in Cleveland found the tabs also reduced noise by mixing hot and cool air. In the 1990s Dennis Huff and colleagues found that a serrated, saw-tooth shape held more promise, and that shape became the chevron.

NASA contracted General Electric and Pratt & Whitney to develop designs, and in 1998 funded engine tests of the 14 most promising. Flight tests followed in March 2001 on NASA's Learjet 25. GE's CF34-8, the first commercial engine with chevrons, first flew on a Bombardier CRJ900 in 2003. Larger engines such as GE's GEnx followed.

What the teeth do

Wikipedia's turbofan article says the serrations blend the fast, hot core exhaust with the slower, cooler bypass air by creating streamwise vortices where the two meet, which reduces turbulence-generated noise. Migflug's NASA feature describes each tooth dipping slightly into the faster inner airflow. Huff put the noise reduction at about three decibels.

Which jets have them

NASA's own article on the technology names the 787 and the 737 MAX. A separate NASA page, which credits Boeing as an industry partner, names the 787 and the 747-8 and quotes Boeing as saying the engines with chevrons give the 787 a 69% smaller noise footprint and the 747-8 a 29% smaller one. The page gives no baseline, so I would not read much into them.

Wikipedia lists the engines as the Rolls-Royce Trent 1000 and GE GEnx on the 787, the GEnx on the 747-8, and the CFM LEAP-1B on the 737 MAX, naming that one LEAP variant only.

What they cost

In its 1998 engine tests NASA measured a negligible 0.25% reduction in thrust. Some trade sites quote a range up to 0.5%. I could not trace the upper figure to an engineering source, so I am using NASA's.

The 777X went without

Migflug says the GE9X nacelles on the 777X have smooth trailing edges. AvGeekery, summarising Simple Flying, reports that Boeing left chevrons off the 777X and quotes a Boeing 777X engineer saying a new nozzle design gives equivalent noise at lower weight and drag. I have not found Boeing's own statement, so treat that explanation as reported rather than confirmed.

On my screen

On 27 September a British Airways 787-10, G-ZBLI, flying BAW189 from Heathrow to Newark, crossed my radar at 8,000 feet. I have not checked which engine variant it carries, so I am not claiming anything about its nacelles beyond NASA's statement that the 787 uses chevrons.

What I could not confirm

  • A figure of about 600 lb (272 kg) of cabin insulation saved on the 787 appears on several sites. Boeing's own 2005 release says only that the results could reduce sidewall insulation by "several hundred pounds", so I have left the larger number out.
  • Figures of 6 dB and 15 dB appear online. I traced only NASA's three decibels and Boeing's 2005 result of up to two decibels (777-300ER tests) to a source.
  • I did not find a licensed photograph of the 747-8's chevrons, so the pictures here show a 787 and a 737 MAX.

The photographs

The 787 photo is by markjhandel (Flickr), CC BY 2.0, dated July 2007 on Commons, and shows a Rolls-Royce-powered 787. The 737 MAX photo is by Thyrome, CC0, taken at Alghero in April 2024.

Sources